Wiring Connections - Viper 4811V Owner's Manual

Wiring Connections

Main Harness, White 6-pin connector
RED
1
2 BLACK
3 BROWN
4 WHITE/BROWN
5 WHITE
6 ORANGE
Auxiliary/Shutdown Harness, White 24-pin connector
1 PINK/WHITE
2 BLUE/WHITE
3 RED/WHITE
4 BLACK/YELLOW
5 DARK BLUE
6 WHITE/BLACK
7 WHITE/VIOLET
8 ORANGE/BLACK
9 GRAY
10 BLUE*
11 WHITE/BLUE
12 VIOLET/WHITE**
13 BLACK/WHITE***
14 GREEN/BLACK
15 GREEN**
16 EMPTY
17 PINK
18 VIOLET**
19 VIOLET/BLACK
20 BROWN
21 VIOLET/YELLOW
22 GRAY/BLACK
23 ORANGE
24 GREEN/WHITE
* This optional input can be connected to the horn circuit (+ or -) in vehicles with factory alarm. When this
wire receives input for a minimum of 5 seconds, the system reports a trigger on the 2-way remote.
** Required connection for manual transmission vehicles.
***Connect this wire to the (-) Parking Brake wire in the vehicle (see Owners Guide for manual transmission
procedure).
Important: NEVER connect 200mA low current outputs directly to a motor or high current device WITHOUT
a relay.
6
(+)12V DC CONSTANT INPUT
(-) CHASSIS GROUND
(-) 200mA HORN HONK OUTPUT
PARKING LIGHT ISOLATION WIRE - #87a NORMALLY CLOSED of onboard relay
PARKING LIGHT OUTPUT- #30 COMMON of onboard relay
(-) 500 mA (GWA) GROUND WHEN ARMED OUTPUT
(-) 200mA IGNITION 2/FLEX RELAY OUTPUT
(-) 200mA 2ND STATUS/REAR DEFOGGER OUTPUT
(-) 200mA TRUNK RELEASE OUTPUT
(-) 200mA DOME LIGHT OUTPUT
(-) 200mA STATUS OUTPUT
(-) 200mA AUX 3 OUTPUT
(-) 200mA AUX 1 OUTPUT
(-) 200mA AUX 4 OUTPUT
(-) HOOD PIN INPUT (N/O or N/C)
(+) or (-) FACTORY HORN INPUT (Use Jumper to set polarity)
ACTIVATION INPUT
TACHOMETER INPUT
(-) PARKING BRAKE/E-BRAKE INPUT
(-) 200mA FACTORY ALARM DISARM OUTPUT
(-) DOOR INPUT (N/O or N/C)
------------------------------------
(-) 200mA IGNITION 1 OUTPUT
(+) DOOR INPUT
(-) 200mA AUX 2 OUTPUT
(+) BRAKE SHUTDOWN INPUT
(-) 200mA STARTER OUTPUT
(-) DIESEL WAIT TO START INPUT
(-) 200mA ACCESSORY OUTPUT
(-) 200mA FACTORY ALARM ARM OUTPUT
© 2015 Directed. All rights reserved.