Viper 4205V Owner's Manual
  1. Manuals
  2. Brands
  3. Viper Manuals
  4. Remote Starter
  5. 4205V
  6. Owner's manual

Viper 4205V Owner's Manual

Viper 4205v remote start system owner's guide
Hide thumbs Also See for 4205V:
Table of Contents

Advertisement

Quick Links

®
NO ONE DARES
COME CLOSE
®
O W N E R' S G U I D E
M
O
D
E
L
42 0 5 V

Advertisement

Table of Contents
loading

Related Manuals for Viper 4205V

Summary of Contents for Viper 4205V

  • Page 1 ® NO ONE DARES COME CLOSE ® O W N E R’ S G U I D E 42 0 5 V...

  • Page 2: Congratulations

    Congratulations Congratulations on the purchase of your remote start system. Reading this Owner’s Guide prior to using your system will help maximize the use of your system and its many features. For any additional questions please contact your authorized Directed dealer or contact Directed at 1-800-753-0600.

  • Page 3: Battery Information

    Battery Information The remote control is powered by two coin cell batteries (CR-2016) that can be purchased at most retailers. The operating range diminishes as the battery charge depletes. Replacing the Battery If present, remove the small screw on the back of the remote. Use a small flat blade screw driver and insert it into the slot located along the bottom of the remote, near the key ring.

  • Page 4: Table Of Contents

    Contents Congratulations ....................i Important Information ..................i Government Regulations and Safety information ..........i Your Warranty ...................i Replacement remote controls ...............i Battery Information .................... ii Replacing the Battery ................ii Battery Disposal ..................ii Using Your System ...................2 Commands At a Glance ................2 Start Engine .....................2 Unlock Doors ...................2 Stop Engine .....................2...

  • Page 5: Using Your System

    Using Your System Commands At a Glance System State Press/Hold for 3 sec. Press/Release ENGINE OFF START ENGINE CAR FINDER ENGINE ON UNLOCK DOORS STOP ENGINE Start Engine When the engine is OFF, press and release the remote control button to start the engine.

  • Page 6: Car Finder

    Car Finder When the engine is OFF, press and hold the remote control button for three seconds. The parking lights flash ten times. The remote responds with 1 short beep and the orange LED on the remote flashes once. Using Remote Start Important! (1) Never remotely start the vehicle with the ve- hicle in gear, and (2) Never remotely start the vehicle with the key in the ignition.

  • Page 7: Safety Features

    Note If your vehicle uses a Smart Key or PTS (Push-To-Start) sys- tem, please refer to the vehicle specific instructions included with the owner's guide of the interface module or consult your authorized dealer. Safety Features The following safety features will disable the remote start when acti- vated or not allow the engine to start if not properly set before starting.

  • Page 8: Optional Rear Defogger

    Note If your vehicle uses a Smart Key or PTS (Push-To-Start) sys- tem, please refer to the vehicle specific instructions included with the owner's guide of the interface module or consult your authorized dealer. Optional Rear Defogger If connected, the Defogger circuit automatically activates after remote starting the vehicle.

  • Page 9: Remote Programming

    Remote Programming Turn key to the ON position Within 10 seconds, press and release Valet button one time. Within 10 seconds, press and hold the Valet button. The LED on the mod- ule flashes one time and the horn honks (if connected) to confirm entry into remote programming.

  • Page 10: Patent Information

    Ignition switch controlled door locking on or OFF. With this feature • on, the doors will lock 3 seconds after the ignition key is turned on, and unlock when the key is turned off. Important: The door lock option must be installed for this feature to work.

  • Page 11: Government Regulations

    Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation.

  • Page 12: Warning! Safety First

    Warning! Safety first The following safety warnings must be observed at all times: Installation Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. Remote Start Capable When properly installed, this system can start the vehicle via a command signal from the remote control.

  • Page 13: Interference

    consult with the authorized Directed dealer to fix the problem. After the remote start module has been installed, contact your authorized dealer to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed.

  • Page 14: Water/Heat Resistance

    Water/Heat Resistance This product is not designed to be water and/or heat-resistant. Please take care to keep this product dry and away from heat sources. Any damage from water or heat will void the warranty. © 2013 Directed. All rights reserved.

  • Page 15: Limited Lifetime Consumer Warranty

    Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reason- able use during the lifetime of the vehicle provided the following conditions are met: the unit was purchased from an authorized Directed dealer, the unit was professionally installed...
  • Page 16 IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE PRICE OF THE UNIT.
  • Page 17 The company behind Viper Auto Security ® Systems is Directed. Since its inception, Directed has had one purpose, to provide consumers with the fin- est vehicle security and accessories avail- able. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology.

  • Page 18: Wiring Connections

    Guide Translations Installation Points Reset and Deletion Quick Reference Install Guide For a Spanish version of the Installation Guide, please download it from Tach Learning www.directechs.com under Resources. If a feature/virtual tach needs to be reset or the remote controls need to be deleted, Remote Start with Keyless Entry use the following procedure.
  • Page 19 Programming System Features Feature Menus Remote Programming Default settings are in bold type. The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of the Turn key to the ON position feature settings using the Valet button. Within 10 seconds, press and release Valet button one time.

Table of Contents