Viper 4811V Owner's Manual page 50

Vehicle Setup for Pairing:
• Turn ON the vehicles ignition to the RUN position.
• Within 5 seconds press and release the Control Center button on the Control Center one time then
press it once more and hold it.
• The Control Center LED will begins flashing in a single flash pattern and the horn (if connected) will
sound once to confirm the system is in pairing mode. You may now release the Control Center button.
3. With both the remote and system in pairing mode, press the
to indicate the system has learned the remote ID and is sending its ID to the 2-way remote (the 2-way
remote will emit several tones to indicate the remote has learned the system ID, the 1-way remote does
not offer confirmations).
4. If pairing fails, press the
5. Once the pairing is completed turn OFF the ignition in the vehicle, the horn (if connected) will sound to
confirm exiting. When both the system and remote have exited the Pairing mode, test for functionality.
To exit Pairing Mode on the remote:
• Wait 30 seconds without pressing a button on the remote.
• Press and release the
To exit Pairing Mode on the system:
• Turn OFF the ignition.
• Wait 60 seconds for the system to automatically exit.
• The horn (if connected) will sound to confirm exiting.
1 Button 2-way or 1-way Remote Control:
1. Press the button on the remote control twice and then hold on the third press. The transmit LED will
come on solid, continue to hold the button until the transmit LED changes its pattern. Release the
button and the transmit LED will begin flashing as an indication that the remote has entered the pairing
mode.
Vehicle Setup for Pairing:
• Turn ON the vehicles ignition to the RUN position.
• Within 5 seconds press and release the Control Center button on the Control Center one time then
press it once more and hold it.
• The Control Center LED will begins flashing in a single flash pattern and the horn (if connected) will
sound once to confirm the system is in pairing mode.
• You may now release the Control Center Button.
2. With both the remote and system in pairing mode, press and hold the button on the remote. The horn
sounds to indicate the system has learned the remote ID and is sending its ID to the 2-way remote (the
2-way remote will emit several tones to indicate the remote has learned the system ID, the 1-way remote
does not offer confirmations)
3. If pairing fails, press the button on the remote again to attempt another pairing.
4. Once the pairing is completed turn OFF the ignition in the vehicle, the horn (if connected) will sound to
confirm exiting. When both the system and remote have exited the Pairing mode, test for functionality.
To exit Pairing Mode on the remote:
• Wait 30 seconds without pressing a button on the remote.
To exit Pairing Mode on the system:
• Turn OFF the ignition.
• The horn (if connected) will sound to confirm exiting.
25
button on the remote again to attempt another pairing.
button on the remote.
button on the remote. The siren chirps
© 2015 Directed. All rights reserved.