Viper 4811V Owner's Manual page 37

Pink/White: IGNITION 2/FLEX RELAY OUTPUT
This wire typically is connected to the Ignition 2 circuit in the vehicle. If the vehicle does not have a 2nd
Ignition but does have a 2nd accessory or a 2nd starter, it can be programmed to be used to power additional
Accessory or Starter circuits in the vehicle (see Flex Relay Function in Feature Menus for more details).
Red: (+) 12V INPUT
This wire connects to a (+) 12V source and is the power feed for the onboard Ignition relay.
Violet: STARTER OUTPUT
This wire connects to the Starter wire in the vehicle.
Note: Some newer vehicles may not have a Starter wire at the ignition switch, therefore it may not need to
be connected to the vehicle.
Orange: ACCESSORY OUTPUT
This wire connects to the Accessory circuit in the vehicle and operates as the Accessory wire at the ignition
switch. When the remote start is activated this wire will activate, deactivate during the cranking cycle of the
remote start, and will re-activate after the cranking cycle is done.
Red/White: (+) 12V INPUT
This wire connects to a (+) 12V source and is the power feed for the onboard Ignition 2/Flex Relay.
Pink: IGNITION INPUT/OUTPUT
This wire connects to the main Ignition circuit in the vehicle. It will supply voltage to the Ignition circuit in the
vehicle during the remote start sequence and is also the Ignition input to the unit while the remote start is not
activated.
Door Lock, 3-pin connector
Blue: (-) UNLOCK OUTPUT
This (-) 500mA output connects to the (-) unlock wire in the vehicle or to a relay for vehicle specific applications.
This wire will output a pulse when unlocking the system. It can be programmed to unlock the vehicle when the
ignition is turned OFF, for a double pulse output and for output duration (see Ign-controlled Locks, Door Lock
Pulses or Door Lock Duration in Feature Menus for more details).
Empty Pin: N/A
Although this connector is not populated with a wire in this position, the pin on the unit supplies a low current
(+) 12V output and is utilized when using P/N 451M Door Lock Relay Module.
Green: (-) LOCK OUTPUT
This (-) 500mA output connects to the (-) lock wire in the vehicle or to a relay for vehicle specific applications.
This wire will output a pulse when locking the system. It can be programmed to lock the vehicle when the
ignition is turned ON, for a double pulse output and for the output duration. Additionally this output may be
used for Comfort Closure for vehicles which can close the windows (and in some cases the sunroof) while
holding the key to the lock position in the door key cylinder (see Ign-controlled Locks, Door Lock Pulses, Door
Lock Duration or Comfort Closure in Feature Menus for more details).
Note: If the door trigger input is connected, the doors of the vehicle must be closed when turning the ignition
ON for the Ign-controlled Door Locks, feature to work.
12 © 2015 Directed. All rights reserved.