Remote Control Learn Routine - Viper 5301 Installation Manual

Remote control learn routine

The system comes with a 1-way and a 2-way remote control that are already
programmed to the system. The system can store up to 4 different remote control
codes in memory.
The remote uses a Supercode Protocol and requires setup before programming
the system.
To enter the remote setup mode on the 1-way and 2-way remotes:
1. Hold the "function" button on the remote until you hear it emit a long beep.
The transmit LED comes on solid (approximately 8 seconds).
2. Press and hold the "remote start" button until the remote beeps three times,
and the amber Transmit LED lights up.
3. Next enter the remote control learn routine and choose the func-
tion for "auto learn configuration" listed on the program grid.
Note: You do not need to go through the setup for the other features in the
menu.
After entering the setup mode on the remote, use the following learn routine to
add remote controls to the system.
The learn routine may be locked if previously programmed using the Bitwriter®.
If the honk generates one long chirp when attempting to program the unit,
the learn routine is locked and must be unlocked using the Bitwriter® before
proceeding.
© 2008 Directed Electronics. All rights reserved.
37