Synchronize File Systems - Cisco ASR 5000 Series Administration Manual

Off-line Software Upgrade
Assign the next highest priority to this entry, by using the <N-1> method, wherein you assign a priority number
that is one number less than your current highest priority.
Run the Exec mode show boot command to verify that there are less than 10 entries in the boot.sys file
Important
and that a higher priority entry is available (minimally there is no priority 1 entry in the boot stack).
If priority 1 is in use, you must renumber the existing entries to ensure that at least that priority is available.
The maximum number of boot stack entries that can be contained in the boot.sys file is 10. If there are already
10 entries in the boot stack, you must delete at least one of these entries (typically, the lowest priority) and,
if necessary, renumber some or all of the other entries before proceeding. Use the no boot system priority
command to delete a book stack entry.
[local]
[local]
To add new boot stack entries to the boot.sys file enter the following commands:
[local]
[local]
For information on using the boot system priority command, refer to the
on page 127

Synchronize File Systems

Synchronize the local file systems on the management cards by entering the following command:
[local]
Save the Running Configuration
Save the currently running, upgraded configuration prior to rebooting the chassis.
To save the running configuration to the current configuration file, enter the following command:
[local]
Reboot the System
Reboot the system by entering the following command:
[local]
As the system reboots, it loads the new operating system software image and its corresponding CLI
configuration file using the new boot stack entry configured earlier.
After the system reboots, establish a CLI session and enter the show version command to verify that the active
software version is correct.
Optional for PDSN: If you are using the IP Pool Sharing Protocol during your upgrade, refer to Configuring
IPSP Before the Software Upgrade in the PDSN Administration Guide.
ASR 5500 System Administration Guide, StarOS Release 21.4
134
host_name configure
#
host_name no boot system priority number
(config)#
host_name
configure
#
host_name boot system priority number image image_url config cfg_url
(config)#
.
host_name filesystem synchronize all
#
host_name save configuration /flash
#
host_name reload [-noconfirm]
#
Software Management Operations
Adding a New Boot Stack Entry,