Asr 5500 System Administration Guide, Staros Release 21.4 - Cisco ASR 5000 Series Administration Manual

Getting Started
Step 5
Enter the following command to configure a hostname by which the system will be recognized on the network:
host_name
[local]
host_name is the name by which the system will be recognized on the network. The hostname is an alphanumeric string
of 1 through 63 characters that is case sensitive.
Step 6 Configure the network interfaces on the MIO/UMIO/MIO2 using the following instructions:
a) Enter the context configuration mode by entering the following commands:
host_name
[local]
host_name
[local]
b) Enter the following command to specify a name for the interface:
host_name
[local]
interface_name is the name of the interface expressed as an alphanumeric string of 1 through 79 characters that is
case sensitive. The following prompt appears as the system enters the Ethernet Interface Configuration mode:
host_name
[local]
c) Configure an IP address for the interface configured in the previous step by entering the following command:
{ ip address | ipv6 address } ipaddress subnetmask
If you are executing this command to correct an address or subnet that was mis-configured with the Quick Setup
Wizard, you must verify the default route and port binding configuration. Use step 11 and step 6 of this procedure.
If there are issues, perform steps 7e through 7k to reconfigure the information.
d) Enter the following command to exit the Ethernet interface configuration mode:
host_name
[local]
host_name
[local]
e) Configure a static route, if required, to point the system to a default gateway. Entering the following command:
{ ip | ipv6 } route gw_address interface_name
f) Enter the following to exit from the context configuration mode:
host_name
[local]
host_name
[local]
g) Enter the Ethernet Port Configuration mode:
port ethernet slot#
h) Bind the port to the interface that you created in step 7b. Binding associates the port and all of its settings to the
interface. Enter the following command:
host_name
[local]
host_name
[local]
interface_name is the name of the interface that you configured in step 7b.
i) Exit the Ethernet Interface Configuration mode by entering the command:
host_name
[local]
host_name
[local]
Important
system hostname host_name
(config)#
context local
(config)#
(config-ctx)#
interface interface_name
(config-ctx)#
(config-if-eth)#
exit
(config-if-eth)#
(config-ctx)#
exit
(config-ctx)#
(config)#
port#
/
(config-port-<slot#/port#>)#
(config-port-<slot#/port#>)#
(config-port-<slot#/port#>)#
(config)#
Refer below for instructions on configuring the MIO/UMIO/MIO2 management interface with a second
IP address.
Using the CLI for Initial Configuration
bind interface interface_name local
no shutdown
exit

ASR 5500 System Administration Guide, StarOS Release 21.4

25