Mio Busy Led States - Cisco ASR 5000 Series Administration Manual

Troubleshooting
Color Description
None This card is the Standby MIO.
OR
Card has failed.

MIO Busy LED States

The Busy LED on the MIO/UMIO/MIO2 indicates that the card is accessing the RAID solid state drives on
the FSCs.
This LED is off when no file storage activity is occurring.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 19: MIO Busy LED States
Color Description
Green Files are being transferred to or
accessed from the RAID
configuration on the FSCs.
None No RAID activity.
OR
RAID configuration is
unavailable.
MIO – Interface Link LED States
The Link LED associated with a 1000Base-T (management) or 10 Gigabit Ethernet port on an MIO/UMIO
daughter card (subscriber traffic) indicates the status of the network link. This LED should be green for normal
operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 20: MIO – Interface Link LED States
Color Description
Green Link is up
Troubleshooting
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST results are positive. If it is off, refer to
page 202 for troubleshooting information.
Refer to Monitoring the System for information on determining the status of he
MIO/UMIO/MIO2 and system software processes.
Troubleshooting
None required.
Checking the LEDs on the FSC, on page 209
Troubleshooting
None needed.
NOTE: This LED will not indicate the presence of a network link until the
interface parameters are set during the software configuration process.
ASR 5500 System Administration Guide, StarOS Release 21.4
Checking the LEDs on the MIO Card
MIO Run/Fail LED States, on
205