Show Commands - Cisco ASR 5000 Series Administration Manual

SRP CLI Commands
Command
srp initiate-switchover
srp reset-auth-probe-fail
srp reset-diameter-fail
srp terminate-post-process
srp validate-configuration
srp validate-switchover
For release 20.0 and higher, ICSR will verify session manager connectivity on both chassis prior to allowing
Important
a manual switchover. If one or more of the session managers in the active chassis is not connected on the
standby chassis, the switchover will not be initiated. An error message will appear on the screen noting
the number of session managers that are mismatched. The force keyword can be used to initiate the
switchover despite the mismatch(es). The output of the show checkpoint statistics verbose command
will not indicate "Ready" for a session manager instance ("smgr inst") in the "peer conn" column for any
instance that is not connected to the peer chassis.

show Commands

Exec mode show srp commands display a variety of information related to SRP functions. The table below
lists and briefly describes these commands. For complete information on these commands, see the Exec Mode
show Commands (Q-S) chapter of the Command Line Interface Reference.
Table 45: show srp Commands
Command
show srp audit-statistics
show srp call-loss statistics
show srp checkpoint statistics
show srp info
show srp monitor
show srp statistics
ASR 5500 System Administration Guide, StarOS Release 21.4
336
Description
Executes a forced switchover from active to inactive. When executed
on the active chassis, this command switches the active chassis to
the inactive state and the inactive chassis to an active state. See Note
below.
Resets the auth probe monitor failure information to 0.
Resets the Diameter monitor failure information to 0.
Forcibly terminates post-switchover processing.
Validates the configuration for an active chassis.
Validates that both active and standby chassis are ready for a planned
SRP switchover.
Description
Displays statistics of an external audit.
Displays the history of calls lost during switchover.
Displays check pointing statistics on session redundancy data (session
managers, current call recovery records, etc.).
Displays Service Redundancy Protocol information (context, chassis
state, peer, connection state, etc.).
Displays SRP monitor information.
Displays SRP statistics (hello messages sent, configuration validation,
resource messages, switchovers, etc.).
Interchassis Session Recovery