Shutting Down - Beckhoff C5101 Installation And Operating Instructions Manual

Dismantling the Industrial
PC
Observe national
electronics scrap
regulations
Troubleshooting
Fault
Nothing happens after the Industrial
PC has been switched on
The Industrial PC does not boot
fully
Computer boots, software starts,
but control does not operate
correctly
Error during CD access
The Industrial PC functions only
partially or only part of the time, e.g.
no or dark picture, but disk drive
responds when switching on
C5101

Shutting down

Disposal
The device must be fully dismantled in order to dispose of it. The housing
can be sent for metal recycling.
Electronic parts such as disk drives and circuit boards must be disposed of
in accordance with national electronics scrap regulations.
Please also refer to chapter
Fault correction
Cause
No power supply to the Industrial
PC.
Other cause.
CD in drive.
Setup settings are incorrect.
Other cause.
Cause of the fault is either in the
software or in parts of the plant
outside the Industrial PC.
Faulty CD.
Faulty disk drive.
Defective components in the
Industrial PC.
General Notes.
Procedure
Check power supply cable.
Call Beckhoff Service..
Remove CD and press any
key.
Check the setup settings.
Call Beckhoff Service.
Call the manufacturer of the
machine or the software.
Check the disk in another
disk drive.
Call Beckhoff Service.
Call Beckhoff Service.
Troubleshooting
15