Mitsubishi S4S Service Manual page 91

. - - - - - - - - - 1 NOrf
' 1 -- ---,
To squeeze out a4 mm [0.2 in.] thickness ofThree
Bond, cut the first node of the nozzie.
ENGINE MAIN PARTS
Nozzle for Three Bond 12Ü7Ctube
(11) Installing crankshaft pulley
Install two safety bars
(MI2 x 1.25)
to the rear end
of the crankshaft. Put a bar between the safety bars
to hold the crankshaft. Under this condition, install
the crankshaft pulley and tighten the nut to the
specified torque.
Tightening torque for
crankshaft pulley nut
Î!\WARNING
480 to 500 Nrn
(49 to 51 kgf-m)
[354 to 369 lbf-ft]
Installing crankshaft pulley
Be on standby to act when the safety bar comes
off inadvertently.
(12) Installing damper (S6S/-DT)
Hold the crankshaft with safety bars and install
the damper.
Installing damper
7-29