Mitsubishi S4S Service Manual page 87

ENGINE MAIN PARTS
(1)
Installing front plate
3.3 Reassembly
(b) Tighten the bolts that hold the front plate to
the crankcase to the specified torque.
Installing front plate
10.0 to 13.0 N·m
(1.0 to 1.3 kgf-m)
[7.23 to 9.40 lbf-ft]
Tightening torque for
front plate bolts
(a) Put the gasket on the crankcase, making sure
the dowels enter the holes in the gasket.
(c) Cut off the excess of the gasket with a cutter.
(2)
Installing camshaft gear and thrust plate
(a) Heat the camshaft gear for installation.
(b) Have the thrust plate installed in advance.
Installing camshaft gear and thrust plate
(3)
Installing camshaft
(a) Apply engine oil to the lobes andjoumals of
the camshaft.
(b) Carefully put the camshaft in the bore in the
crankcase.
Installing camshaft
10.0 to 13.0 N·m
(1.0 to 1.3 kgf-m)
[7.23 to 9.40 IbHt]
Tightening torque for
front plate bolts
(c) Tighten the bolts that hold the thrust plate to
the specified torque.
r-------1&,CAUTION
1 - - - - - - - . ,
Do not cause damage to the lobes and bushings.
7-25