Turning Off The Computer - IBM IntelliStation E Pro 6216 Installation Manual

Turning off the computer

Use one of the following procedures to turn off your computer.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
v You can press the power-control button on the front of the computer. This starts
v You can press and hold the power-control button for more than 4 seconds to
v If you cannot use the power-control button to turn off your computer, disconnect
an orderly shutdown of the operating system, if this feature is supported by your
operating system, and places the computer in Standby mode.
Note: After you turn off the computer, wait at least 5 seconds before you press
the power-control button to turn on the computer again.
cause an immediate shutdown of the computer. You can use this feature if the
operating system stops functioning.
the computer power cords from the electrical outlets.
Note: After disconnecting the power cords, wait approximately 15 seconds for
your system to stop running.
Chapter 2. Installing the hardware
39