Starting The Broadcom Multi-Boot Agent Program - IBM IntelliStation E Pro 6216 Installation Manual

Starting the Broadcom Multi-Boot Agent program

The Broadcom NetXtreme Gigabit Ethernet Boot Agent program is a built-in
configuration utility program that you can use to configure the computer to start
from the network. You enable the Broadcom NetXtreme Gigabit Ethernet Boot Agent
program and establish your network as a startup device using the
Configuration/Setup Utility program.
To enable Broadcom NetXtreme Gigabit Ethernet Boot Agent, complete the
following steps:
1. From the Configuration/Setup Utility main menu, select Devices and I/O Ports
2. Select System Board Ethernet PXE/DHCP and use the Right Arrow (→) key to
3. Select Save Settings and press Enter.
For details about using the Configuration/Setup Utility program to configure the
computer to start from the network, see the User's Guide on the IBM IntelliStation
Documentation CD.
Starting the SCSISelect utility program (some models)
SCSISelect is a menu-driven configuration utility program that you can use to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
Note: If your server has a redundant array of independent disks (RAID) adapter
Complete the following steps to start the SCSISelect Utility program:
1. Turn on the computer and watch the monitor screen.
2. When the <<< Press <CTRL><A> for SCSISelect¬ Utility! >>> prompt
3. When the Would you like to configure the host adapter or run the SCSI
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected
Starting the Boot Menu program
Complete the following steps to start the Boot Menu program:
1. Turn on the computer and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup, Press F12 for Boot
3. Follow the instructions that appear on the screen.
and press Enter.
set it to Enabled.
installed, use the configuration method that is supplied with the RAID
adapter to view or change SCSI settings for devices attached to the adapter.
appears, press Ctrl+A.
disk utility? question appears, make your selection and press Enter.
items; then, press Enter.
Menu appears, press the F12 key.
Chapter 3. Configuring the computer
43