IBM IntelliStation E Pro 6216 Installation Manual page 31

Internal drive bays: The IntelliStation E Pro Type 6216 computer comes with an
IDE CD-ROM, DVD-ROM, or CD-RW drive in bay 1; a 3.5-in., 1.44-MB diskette
drive in bay 2; and a hard disk drive installed in bay 3.
Notes:
1. The IntelliStation E Pro computer supports only one diskette drive.
2. The IntelliStation E Pro Type 6216 does not support the installation of additional
internal disk drives. However, you can replace failed internal drives. If you want
to replace an internal drive, see the User's Guide.
3. For a complete list of supported options for your computer, go to
http://www.ibm.com/pc/support/ on the World Wide Web.
Installing memory modules
You can increase the amount of memory in your computer by installing memory
modules. Your IntelliStation E Pro computer uses industry-standard, PC2100 266
MHz double density RAM (DDR) dual inline memory modules (DIMMs).
Complete the following steps to install a DIMM.
Attention: When handling static-sensitive devices, take precautions to avoid
damage from static electricity. For details about handling these devices, see
"Handling static-sensitive devices" on page 11.
1. Review the safety precautions listed in "Safety information" on page v.
2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then, remove the cover. See "Removing the cover" on
page 15 or for details.
3. Lift the frame-support bracket. See "Removing the frame-support bracket" on
page 15.
4. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the computer. Then, remove the new DIMM from the
package.
5. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM
so that the pins align correctly with the connector.
Bay 3
Bay 2
Bay 1
Chapter 2. Installing the hardware
19