IBM IntelliStation E Pro 6216 Installation Manual page 46

10. Reconnect the external cables and power cords. Turn on the attached devices,
Installing a security rope clip
To help prevent theft, you can add a rope clip and cable to your computer.
Complete the following steps to install the rope clip:
1. Review the safety precautions listed in "Safety information" on page v.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
34
IBM IntelliStation E Pro Types 6216 and 6226: Installation Guide
3. Rotate the drive cages until the drive-cage latches catch the chassis.
4. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the computer. Then, remove the new DIMM from the
package.
5. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM
so that the pins align correctly with the connector.
6. Insert the DIMM into the connector. Firmly press the DIMM straight down into
the connector by applying pressure on both ends of the DIMM simultaneously.
The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector.
7. If there is a gap between the DIMM and the retaining clips, the DIMM has not
been correctly installed. Open the retaining clips, remove the DIMM, then
reinsert it.
8. If you have other options to install or remove, do so now.
9. Replace the cover. See "Replacing the cover" on page 35.
and turn on the computer.
and power cords; then, remove the cover. See "Removing the cover" on
page 25 for details.
DIMM connector 1
DIMM connector 2