IBM IntelliStation E Pro 6216 Installation Manual page 32

10. Replace the cover. See "Replacing the cover" on page 21.
11. Reconnect the external cables and power cords. Turn on the attached devices,
Installing a security rope clip
To help prevent theft, you can add a rope clip and cable to your computer.
Complete the following steps to install the rope clip:
1. Review the safety precautions listed in "Safety information" on page v.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
20
IBM IntelliStation E Pro Types 6216 and 6226: Installation Guide
6. Insert the DIMM into the connector. Firmly press the DIMM straight down into
the connector by applying pressure on both ends of the DIMM simultaneously.
The retaining clips snap into the locked position when the DIMM is firmly
seated in the connector.
7. If there is a gap between the DIMM and the retaining clips, the DIMM has not
been correctly installed. Open the retaining clips, remove the DIMM, and then
reinsert it.
8. If you have other options to install or remove, do so now.
9. Replace the frame-support bracket.
and turn on the computer.
and power cords; then, remove the cover. See "Removing the cover" on
page 15 for details.
DIMM connector 1
DIMM connector 2