IBM IntelliStation E Pro 6216 Installation Manual page 27

Removing the cover
To remove the cover from the IntelliStation E Pro Type 6216 computer, complete
the following steps:
1. Review the information in "Safety information" on page v and "Before you begin"
on page 10.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords.
4. Press the buttons on both sides of the computer cover and lift the cover from
the computer.
To replace the cover, see "Replacing the cover" on page 21.
Removing the frame-support bracket
You must remove the frame-support bracket to access many of the components of
the IntelliStation E Pro Type 6216 computer. To remove the frame-support bracket,
complete the following steps:
1. Pivot the drive cages until the pivot locks catch the front of the chassis, holding
the drive cages in place.
2. Lift the frame-support bracket out of the computer.
To replace the frame-support bracket, reverse the steps.
Chapter 2. Installing the hardware
15