Adjust Handset Microphone Gain - EnGenius SP-935 User Manual

2. If the handset still indicates the icon even after you have listened all messages, turn it off
by pressing and holding "Caller ID" key on the handset.

Adjust Handset Microphone Gain

In case you will use the handset in different workplace or environment, to perform
better voice quality for the other end, you can adjust the handset microphone gain
to suit for variable place.
a. Press MENU right soft key while the handset is in the standby mode.
b. Press 5 (Phone Settings), followed by
c. Use
or key to scroll the "Standard", "Medium" and "Low"
options.
d. If you are using the handset in quiet environment, like office or meeting
room, the level of "Standard" is recommended.
If you are using the handset in a noisy environment, like factory or
outdoor place, the level of "Medium" or "Low" is recommended.
Adjust Headset Ring
When using headset, to avoid missing the call due to the ringer emitted from
receiver of headset, you can change the ringer emitting from either handset
speaker or receiver of headset.
a. Press MENU right soft key while the handset is in the standby mode.
b. Press 5 (Phone Settings), followed by "9" to enter the "Headset Ring"
menu.
c. Select On , the ringer will be emitted from the receiver of headset; If
select Off , the ringer will be emitted from handset speaker.
1 to enter the "Mic. Gain" menu.
~49~
SIP Configuration
Introduction
The SP-935 is a long range cordless telephone system which built-in a SIP client
along with a traditional FXO port. It provides user the capability to make VoIP call or
PSTN call via different ports. Below describes how to setup the SIP configuration of
SP-935 base from web.
Application
Typically, the SP-935 is able to connect with a legacy PBX (or PSTN line) via a
telephone jack, and in addition with an IPPBX via a networking jack. These two
interfaces are perfectly suitable for adjunct telephone system for enterprise
environment as following figure.
VoIP Features
- Support 3 VoIP and 1 PSTN line calls simultaneously.
- Each handset has only one SIP account.
- Up to register 10 SIP accounts and 10 handsets accordingly.
- Flexible call manager feature to dedicate the SIP or PSTN call.
- Use G.711U-law for VoIP codec
- SIP and LAN setting from web configuration
- Internet interface: 10/100base-T LAN port x1
Registration handsets
- Before setting the SIP configuration, the available handset(s) of SP-935 must
register to the base of SP-935.
- Register handset:
(1) Press and hold the register key on base till the "Intercom" key into flashing
status. During this flashing LED period, the base can perform the registration.
~50~