Key Guard - EnGenius SP-935 User Manual

＊
within 2 seconds, press the digit
3. Once returning back to standby mode for 15 seconds, the
keyguard will be automatically enabled.
4. Key Guard is in effect until unlocked.
Battery Recharge and Replacement
1. Charge the battery when one or several of the following happen:
a. Phone beeps twice (every 60 seconds in talk mode, every 10 minutes in
standby mode).
b. Battery icon is empty.
c.
Phone does not respond when a power on/off key
d. LCD and backlighting become dim.
e. Talk range shortfall is experienced.
2. You can replace the handset battery after placing the call-in-progress on hold
and press key. To retrieve the call on held, press talk key again after
replaced battery and power the handset on..
3. Battery talk time and standby time vary depending on the talk/standby pattern
and the operating distance. Putting the handset back to charger cradle as
often as possible is recommended for best performance. Use only
manufacturer provided battery and charger!
to unlock.
is pressed.
~35~
Advanced Operations
Handset Registration
1. If your handset(s) is purchased as part of a system, it has been pre-registered
with the base station at the factory.
2. If Handset ID as "00," that means it is a new handset or the ID has been
erased. You need to register the handset with the base station.
3. Registration:
a. Press MENU-7 to enter the registration mode
b. Press and hold the base's PAGE button for 3 seconds
until the In Use LED (white color) lighting up and
flashing, also the base station will emit prompt sound
to remind you the base station is in the registration
mode..
c. Press handset key 1 , this completes the registration
process. The base station will assign a handset ID
between 11 and 19 automatically. The assigned ID will
be displayed on the handset LCD, indicating successful
registration.
d. Repeat above steps for all additional handsets.
4. De-registration:
a. You can de-register the handset you're using from the
base station. De-registration will reset the Handset ID
to 00, erase the system security code, and free up the
handset ID for future registration.
b. After deregistration, the handset will not be able to use
the base station to make or receive phone calls, nor can
it intercom other handsets.
c. Press MENU-7 to enter the registration mode
d. Press and hold the base's PAGE button for 3 seconds
until the In Use LED (white color) lighting up and
flashing, also the base station will emit prompt sound to
remind you the base station is in the de-registration
mode.
e. Press the handset number key 2 , this completes the
~36~