Base Features - EnGenius SP-935 User Manual

Base Illustration
CONSOLE
AUDIO IN LINE LAN
Volume
REGISTER DC In
RESET
GROUND
Intercom Broadcast
Receiver
Microphone
~21~

Base Features

Basic Base Station Features
1. Audio in Jack (3.5mm)
Connect to an external device for music on hold
2. FXO Jack (L1)
Standard RJ-11 connector to plug in the telephone line
3. Ethernet Jack
Standard RJ-45 connector to plug in the Ethernet (LAN) line
4. Console jack
Jack for console and firmware upgrade (Type-B USB connector)
5. GND
Connecting the ground cable
6. REG button for Registration and Page
a. Press and hold this REG button till the "INTERCOM" LED into flashing status
to enter registration mode.
Antenna
b. To search a misplaced handset; press "REG" button, all registered handsets
beep for 30 seconds. Press "REG" again or any key on handset to stop.
7. RESET Button
a. Restores base station to factory settings
b. Reset button is intended to prevent accidental system reset.
c. All handsets (including administrator) and additional base(s) need to be re-
registered after a base station reset. The web configuration is also to reset
to factory setting.
8. DC In: to plug in the 12V DC power adaptor
~22~