EnGenius SP-935 User Manual page 10

a. Allow changing the "SP-935" screen to the desired wording or info, such as
the user's name.
Re: Up to 32 characters can be entered.
22. Change Pwd
a. Allow changing the handset password which requires entering in Call
Barring (MENU-4-3) and Menu Display (MENU-8) .
` Re:Default is "0000".
23. DTMF Duration
a. From MENU-6-1 to select variable duration of DTMF tone.
b. Default is 100ms.
c. When entering the Base Settings, PIN is required. Default is "0000".
Re: Better to check with your phone company first before changing it.
24. Programmable Flash key timing
a. From MENU-6-2 to select flash key timing
b. 9-level (100 ms - 900 ms) timing selections, default= 600 ms.
c. The default value (600 ms) works in most areas. Changing this setting may
cause Flash key not working. Change only when you are certain of the new
value would work.
d. When entering the Base Settings, PIN is required. Default is "0000".
25. Assign next handset ID for new handset
a. Using registered handset from MENU-6-3 to assign a next handset ID to a
new handset.
b. If not assign next handset ID, the system will automatically assign a
handset ID to a new handset..
c. When entering the Base Settings, PIN is required. Default is "0000".
26. Clear Handset
a. Using registered handset from MENU-6-4 to remove the other registered
handset, in case the other registered handset is defected.
b. Once clear the other registered handset, the user is able to register a new
handset for instead.
c. When entering the Base Settings, PIN is required. Default is "0000".
27. Change PIN
Allow changing the base PIN which requires entering the "Base Settings"
(MENU-6-5).
a. Using registered handset to change PIN from MENU-6-5.
~19~
b. Default PIN is "0000".
c. When entering the Base Settings, PIN is required. Default is "0000".
28. Auto Hang Up feature
a. Using registered handset from MENU-6-6 to turn on/off the Auto hand up
feature.
b. If turning on the feature, the handset will automatically hang up the call
when the far-end hangs up the call.
c. When entering the Base Settings, PIN is required. Default is "0000".
29. Set Time
The set time function allows user to set date/time to support the DTMF caller
ID (DTMF caller ID doesn't attach date/time when receiving from PSTN, using
this setting, user is able to review the date/time when the caller ID received).
a. Enter MENU-6 to set Base Settings.
b.
Press or scrolling key to select desired base station
c. Enter Base PIN (Default is "0000").
d. Enter 7 to enter Set Time.
e. Enter 6 digits for YY/MM/DD(Year/Month/Day), then enter 4 digits for
hr:mm (Hour：Minute)
f. Press SAVE (Left) soft key to finish the setting.
30. Mic Gain
Allow changing the handset microphone gain based on the handset in
different environment – Quiet, Normal and Noisy environment.
This requires entering the "Phone Settings" (MENU-5-1).
31. Headset Ring
Allow changing the ringer emitted either from handset speaker or receiver of
headset.
This requires entering the "Phone Settings" (MENU-5-8).
~20~