Enable - Redline RDL-3000 User Manual

RDL-3000
id <id>
Remove a
folder <usr | factory | fips>
Remove all files from the specified table.
5.3.6

enable

Use the enable command to enable a specific ID (that was disabled).
Enable a Service Group, Service, or Link id.
enable <id>
Enable a specific ID.
id Unique number for Service Group, Service, or Link.
5.3.7 freq
Use the freq command to configure frequency ranges when using autoscan or DFS.
freq <add> <clearall> <del> <print> <reload>
add <begin> <end>
Add a frequency range (up to 32 ranges).
clearall
Delete all entries from the frequency list.
del <idx>
Delete a frequency validation range
print
Print the list of frequency ranges.
reload
Reload the active list of frequency validation ranges.
70-00158-01-DRAFT
User Manual
usr User entered files (default if type is not specified).
factory Factory default files (requires hardware jumper selection).
fips FIPS mode files.
Service Group Service
,
id Unique number for
usr - User entered files (default).
factory - Factory use only.
fip - FIPS mode files.
begin - start frequency (MHz)
end - end frequency (MHz)
idx - Frequency validation range index. Use 'print' to display IDs.
Local frequency ranges:
index begin end
-------------------------------
0 5810.0 5820.0
1 5830.0 5835.0
Proprietary Redline Communications © 2010
Table 15: CLI - del
Link
, or table entry.
Service Group Service
,
Table 16: CLI - enable
Table 17: CLI - freq
Link
, or .
Page 99 of 142 November 25, 2010