Setting Wireless Rates - Redline RDL-3000 User Manual

RDL-3000
3.2.3

Setting Wireless Rates

The wireless bandwidth is shared between all subscribers in a sector. Use the following
settings to control traffic rates over the wireless interface.
Type
Link
Service
Service
Group
*Unicast traffic with an unknown destination (all RDL-3000 units maintain a forwarding table) is
transmitted two modulation steps below the lowest rate currently in-use across all active
Services.
70-00158-01-DRAFT
User Manual
Table 3: Web - Operation - Wireless Rates`
Function
Select the Uncoded Burst Rate (UBR) for the
link to this subscriber. The RDL-3000 sets
the modulation and coding settings required
to provide the selected rate.
Select the uplink and downlink Committed
Information Rates (CIR) and peak
Information Rates (PIR) rates for unicast*
traffic to/from this subscriber.
Set the rates for downlink multicast and
broadcast traffic belonging to this group.
Fig. 12: PMP - Wireless Rates
Proprietary Redline Communications © 2010
Wireless Settings
Downlink UBR
Uplink UBR
Adaptive modulation mode
Downlink CIR / PIR
Uplink CIR / PIR
Downlink Burst rate
Downlink CIR / PIR
Page 27 of 142 November 25, 2010