Pass Through Mode - Redline RDL-3000 User Manual

RDL-3000
3.2.4

Pass through Mode

Pass through mode is used to process traffic that is untagged or where the VLAN tag
does not match the VID of any Service or Service Group. Ingress and egress packets
processed by a Service Group or Service set to 'Pass through' mode are forwarded
without modification.
Pass through mode can be used to:
Transparently forward all unclassified traffic between two ports (both ports are 'Pass
though' mode).
Add or remove the outermost VLAN tag (Q-in-Q), depending on the direction of the
traffic (only one port is using 'Pass though' mode).
Notes:
1. Only one Service Group (sector controller) may be set to 'Pass though' mode.
2. Only one Service on a subscriber may be set to 'Pass though' mode.
70-00158-01-DRAFT
User Manual
Fig. 13: PMP - Pass through Mode
Proprietary Redline Communications © 2010 Page 28 of 142 November 25, 2010