Table 7: Web - Maximum Tx Power Settings (Dbm) For All Modes - Redline RDL-3000 User Manual

RDL-3000
RF Freq. [MHz]: Enter the center frequency for the RF channel.
The options key controls channel availability. Use the Auto scan feature to enable
subscribers to scan multiple channels.
Important: To minimize interference between RDL-3000 links operating in close
proximity, RF frequency settings should be separated by a guard interval equal or
greater than the channel size. For example, when using a 20 MHz channel, the RF
frequencies should be separated by >20 MHz.
Auto scan: (Subscriber Only) Check this box
automatically scan available channels to locate and register with an RDL-3000 PMP
Master. When Auto scan is not enabled, the wireless link can be established only at the
frequency specified in the RF Freq. [MHz] field.
By default, the subscriber will scan the entire frequency band enabled by the options key
(see section 8.3: Regional Codes on page 138). To reduce the scanning/connection
time, the operator may specify a subset of frequency ranges to scan. Click on the main
menu item Configuration ->
screen.
Tx Power [dBm]: Enter the transmit power level (dBm). This setting is for the
transceiver output only. The actual EIRP depends on the gain of the connected antenna.
See the following tables to determine the maximum transmit power level available at
each modulation setting. When DFS is enabled, the subscriber Tx power may be
adjusted automatically to avoid falsely triggering the DFS feature.
Modulation
Code Rate
Max. Tx Power
70-00158-01-DRAFT
User Manual
Fig. 45: Web - Wireless Configuration Screen -- Subscriber

Table 7: Web - Maximum TX Power Settings (dBm) for All Modes

1/2
25
Proprietary Redline Communications © 2010
Frequencies to display the
BPSK QPSK
3/4 1/2 3/4
25 25 25
to enable the subscriber to
Frequency Management
16 QAM 64 QAM
1/2 3/4 2/3
23 23 22
Page 67 of 142 November 25, 2010
3/4
22