Management Interfaces - Redline RDL-3000 User Manual

RDL-3000
2.8

Management Interfaces

The operator can use a standard web browser to access all settings and statistics
necessary to configure and monitor the operation of the RDL-3000. All functions are also
supported using the Command Line Interface (CLI) using Telnet (see page 95). The
RDL-3000 can also be configured monitored using SNMP (documentation provided
separately). If the IP address, username and/or password have been modified since
installation, contact the network administrator to determine the current settings.
2.8.1 Web Browser (HTTP)
Open a Web browser (Internet Explorer 6 or higher recommended) and enter the unit IP
address. For new systems, the default IP address is 192.168.25.2. The following login
dialog should be displayed:
There is no logout command on the Web interface.
2.8.2 Telnet (CLI)
The RDL-3000 supports two concurrent Telnet sessions. One session with full read/write
capabilities (administrator) and a second concurrent session with read-only access (e.g.,
monitor or show parameter settings).
To connect to the RDL-3000 CLI management, open a Telnet session to the IP address
of the RDL-3000. When the command prompt screen appears, login to the RDL-3000.
Users are logged out automatically when no commands are received (idle) for a period
of ten minutes. Type the following command to exit immediately from the CLI:
logout [ENTER]
2.8.3 SNMP
The RDL-3000 can also be configured and monitored using SNMP (v2c/v3). The Redline
Management Information Base (MIB) is available to operators (documentation provided
separately). The Redline Management Suite is a set of applications designed to assist
provisioning, monitoring and maintaining the Redline components deployed in Radio
Access Networks (RANs). Contact your Redline representative or visit the Redline
website for further information.
70-00158-01-DRAFT
User Manual
Fig. 5: Intro - Web Login to the RDL-3000
Proprietary Redline Communications © 2010 Page 20 of 142 November 25, 2010