Important Notices - Redline RDL-3000 User Manual

RDL-3000
1

Important Notices

1.1 Service & Safety
1.1.1 Safety Warnings
1.
Customer equipment including personal computers, routers, etc., must be connected
only to the INPUT (DATA) port on the PoE unit.
Only the outdoors Ethernet interface cable connecting to the unit can be safely
connected to the OUTPUT (DATA & POWER) connector. Connecting customer
premises Ethernet equipment directly to the OUTPUT (DATA & POWER) connector
on the Power-over-Ethernet power adapter may damage customer equipment.
Installation of the system must be contracted to a professional installer.
2.
Read this manual and follow all operating and safety instructions.
3.
Keep all product information for future reference.
4.
The power requirements are indicated on the product-marking label. Do not exceed
5.
the described limits.
Disconnect the power before cleaning, or when the unit is not be in-use for an
6.
extended period.
The unit must not be located near power lines or other electrical power circuits.
7.
The system must be properly grounded to protect against power surges and
8.
accumulated static electricity. It is the user's responsibility to install this device in
accordance with the local electrical codes: correct installation procedures for
grounding the unit, mast, lead-in wire and discharge unit, location of discharge unit,
size of grounding conductors and connection requirements for grounding
electrodes.
1.1.2 Warning Symbols
These symbols may be encountered during installation or troubleshooting. These
warning symbols mean danger. Bodily injury may result if you are not aware of the safety
hazards involved in working with electrical equipment and radio transmitters. Familiarize
yourself with standard safety practices before continuing.
70-00158-01-DRAFT
User Manual
PoE power adapter caution:
Warning to Service Personnel: 48 VDC
Electro-Magnetic Radiation
Proprietary Redline Communications © 2010
Chapter 1
High Voltage
Page 13 of 142 November 25, 2010