Hitachi P1-00080-L Basic Manual page 53

Chapter 4
4.1.4 Doing a test run...
・This explains the method to how to do a test run using
the keypad.
Home screen
RUN
FW
Output frequency
Output current
Input terminal monitor
Menu oFW
(E)↑ (F)↑
4.1.4.1 Confirm the operation command.
・In the position (E) of the upper illustration, when is
displayed FW or RV, the RUN key of the keypad is
enabled.
⇒Go to [4.1.4.2]
※In the cases that is not displayed, and want to operate
from the keypad, or want to change the RUN command
reference to FW terminal, is necessary to change the
RUN command selection.
⇒Go to
[4.1.4.4 Run Command reference change]
4.1.4.2 Frequency reference status checking.
・In the upper illustration, in the position (F), when values
other than 0.00 are displayed, the frequency reference
is already set. ⇒Go to
※In the case that 0.00 is displayed, is necessary to
change the value of the frequency reference. In the
case that you want to change to an analogue input and
such, the frequency command selection must be
changed.
⇒Go to [4.1.4.5]
4.1.4.3 Start the output by pressing the RUN
key and the motor will accelerate.
※When the motor does not rotate, please refer to the
troubleshooting.
M1
H01
46.49 Hz
11.9 A
LLLLLLLLLLL
46.49
Option
[4.1.4.3]
For parameter configuration
4.1.4.4 RUN command reference change
① Press the RIGHT( ) key, after moving to the
parameter setting screen and by pressing the SEL(O)
key, the parameter section of the parameter setting
screen will blink.
STOP
Output frequency
FA-01
Set Speed-M (Keypad)
Back oFW
② Change the code with UP/DOWN/LEFT/RIGHT
( ) keys to [AA111].
STOP
Output frequency
AA111
RUN command selection_M1
01:[FW]/[RV] terminal
Back oFW
③ Press the SEL(O) key and then with UP/DOWN(
keys select the RUN operation to be executed between
all the choices. In this case [03:Keypad's RUN key] is the
one selected.
STOP
AA111
RUN command selection_M1
00:[FW]/[RV] terminal
01:3-wire
02:Keypad's RUN key
03:RS485
Back oFW
④ To save the changes press the SEL (O) key and then
in the position (E) FW or RV should be displayed. Press
the F1 key, and will go to Home screen.
[4.1.4.2]
⇒Go to
4-5
M1 H03
0.00 Hz
29.51 Hz
29.51
Option
M1
H03
0.00 Hz
[1-8]
29.51
Option
M1
H03
29.51
Option
)