Ipv6 Autoconfig - Tenda DH301 User Manual

address to access the Internet, you can check Disable DHCP Server.
4) Start/End IP Address: Specify the start/end of the range for the IP address pool in the same subnet as the router.
Only enabling DHCP server need you to finish this part configurations.
Leased Time: A time length that the IP address is assigned to each device before it is refreshed.
5)
Static IP Lease List: A list of devices with reserved static IP addresses. If you prefer to configure each upstream
6)
device of your router with a static IP address for better management, you can add static IP addresses to the list.
Add Entries: Click this button to add a static IP lease entry. A maximum 32 entries can be configured.

Remove Entries: Click this button to remove a static IP lease entry.

Configure the second IP Address and Subnet Mask for LAN interface: If you want to configure two IP
7)
addresses for the LAN interface, you can check this option and enter the second IP Address and Subnet Mask manually.
The second IP address and subnet mask have the same function as the first ones.
Apply/Save: After you configure all the needed settings, click this button to apply and save them.
8)
Tip:
DHCP (Dynamic Host Configuration Protocol) assigns an IP address to each device on the LAN/private network. When
you enable the DHCP Server, the DHCP Server will automatically allocate an unused IP address from the IP address pool
specified in this screen to the requesting device as long as the device is set to "Obtain an IP Address Automatically". By
default, DHCP server is enabled.

IPv6 Autoconfig

IPv6 address can only be Aggregatable Global Unicast Addresses and Unique Local Address. Link-Local Unicast
Addresses and Multicast Addresses are not permitted.
Click Advanced > LAN > IPv6 Autoconfig to enter the IPv6 address setting page.
Wireless N300 ADSL2+ High Power Modem Router
87