Ipv6 Autoconfig - Tenda TE-D305 User Manual

Leased Time: The lease time is a time length that the IP address is assigned to each device before it is refreshed.
Static IP Lease List: Displays a list of devices with reserved static IP addresses.
Add Entries: Click to add a static IP lease entry. A maximum 32 entries can be configured.
Remove Entries: Click to remove a static IP lease entry.
Configure the second IP Address and Subnet Mask for LAN interface: If you want to configure two IP addresses for
the LAN interface, you can check this option and enter the second IP Address and Subnet Mask manually.
Apply/Save: After you configure all the needed settings, click this button to apply and save them.
_________________________________________________________________________________________________
TIP
DHCP (Dynamic Host Configuration Protocol) assigns an IP address to each device on the LAN/private network. When
you enable the DHCP Server, the DHCP Server will automatically allocate an unused IP address from the IP address pool
specified in this screen to the requesting device as long as the device is set to "Obtain an IP Address Automatically". By
default, DHCP is enabled.

IPv6 Autoconfig

Static LAN IPv6 Address Configuration

Interface Address (prefix length is required): Enter the interface address.
_________________________________________________________________________________________________
NOTE
1. IPv6 address can only be Aggregatable Global Unicast Addresses and Unique Local Address. Link-Local Unicast
Addresses and Multicast Addresses are not permitted.
2. The IPv6 address must be entered with a prefix length.
_________________________________________________________________________________________________
80