Table of Contents
Advertisement
Bridge
Note
If your country and/or your ISP are not covered on the home page, select Other country and ISP, and set VCI and VPI
value manually. If you cannot locate this information, refer to
For more information, see
3.2.2 Ethernet Mode
1.
Link Type: Select ETH.
2.
Select your Connection Type according to your accessing method.
3.
Secure your wireless network. (Strongly Recommended)
4.
Click OK to apply your configurations.
Note
After saving the Ethernet mode settings, you will see the following prompt:
And then you need to connect the Ethernet cable from the Internet side provided by your ISP to the LAN/WAN port, i.e.
to finish Step 3 of Ethernet Mode in
When Bridge mode is enabled, this device works as a modem. If you wish to initiate
a dialup directly from your PC for Internet access or enjoy the entire Internet
connection by yourself (instead of sharing it with others), you can select Bridge.
To Set up the ATM interface
Chapter 2 Hardware Install-> 2.2 Install the
Wireless N300 ADSL2+ High Power Modem Router
Appendix 4 VPI/VCI List
and
To Set up WAN Service for ATM
Device.
8
or ask your ISP to provide it.
Interface.
Hide quick links:
Advertisement
Table of Contents
