Super Capacitor Module - Lenovo ThinkStation P920 User Manual

e. Pivot the handle
position. Pivot the tab
Figure 124. Closing PCIe card latches
f. Connect the power cable of the full-length PCIe card to the new card. See "Parts on the system
board" on page 6.
7. Reinstall the direct cooling air baffle if you have removed it. See "Direct cooling air baffle" on page 65.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 141.

Super capacitor module

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
To remove or install a super capacitor module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 61.
2. Lay the computer on its side for easier access to the super capacitor module.
3. If necessary, remove the direct cooling air baffle for easier operation. See "Direct cooling air baffle" on
page 65.
4. Locate the PCIe card slot in which the RAID adapter with the super-capacitor-module holder is installed.
See "Computer components" on page 5.
5. To remove a super capacitor module, do the following:
128
P920 User Guide
2 as shown until it stops, and then press it downward until the latch
3
downward until it snaps into position.
1 snaps into