c. Press the mounting stud downward and press the mounting stud downward. Then, turn the
mounting stud 90-degree clockwise to secure the heat sink to the M.2 solid-state drive holder.
Figure 84. Securing the heat sink to the M.2 solid-state drive holder
9. To install the M.2 solid-state drive holder, do the following:
a. Align the notch
1
Then, slide the holder against the multi-function bracket and press the holder downward until the M.2
solid-state drive is securely seated.
Note: Do not touch the circuit board of the M.2 solid-state drive.
Figure 85. Installing the M.2 solid-state drive holder
on the M.2 solid-state drive with the slot key
2
in the M.2 solid-state drive slot.
.
Chapter 7
Hardware removal and installation
103