4. To remove the 3.5-inch storage drive, flex both sides of the bracket to remove the 3.5-inch storage drive
from the bracket.
Figure 21. Removing the 3.5-inch storage drive from the bracket
5. To install a new 3.5-inch storage drive into the front-access storage enclosure, do the following:
a. Flex both sides of the bracket and align pins
new 3.5-inch storage drive.
Notes:
• Ensure that the circuit board faces downward and the connectors face toward the rear of the
bracket.
• Do not touch the circuit board on the storage drive.
Figure 22. Installing the 3.5-inch storage drive into the bracket
1
on the bracket with the corresponding holes in the
.
Chapter 7
Hardware removal and installation
71