Allen-Bradley PowerFlex 755T User Manual page 127

Table 25 - Port 0: Parameter List (continued)
No. Display Name
Extended Name
Description
310 Gateway Cfg 1
311 Gateway Cfg 2
312 Gateway Cfg 3
313 Gateway Cfg 4
Gateway Configuration n
Sets the first, second, third, and fourth byte in the gateway address when parameter
[Net Addr Src] is set to 1 'Parameters' . If the gateway address is 0.0.0.0, the PowerFlex
755T can only communicate with devices on the same subnet as the drive. It is not able
to communicate with devices on other subnets.
If the gateway address is not set to 0.0.0.0, then it must be set to an address that is on
the same subnet as the drive's IP address.
A power cycle or reset is needed for changes to this parameter to take effect.
314 Net Rate Cfg 1
Net Rate Configuration 1
Sets the speed and duplex at which the interface communicates on its ENET n network
port.
A power cycle or reset is needed for changes to this parameter to take effect. Updates
0:315 - [Net Rate Act 1]
315 Net Rate Act 1
Network Rate Actual 1
Displays the active network data rate at which interface n communicates.
316 Net Rate Cfg 2
Net Rate Configuration 2
Sets the speed and duplex at which the interface communicates on its ENET n network
port.
A power cycle or reset is needed for changes to this parameter to take effect. Updates
0:317 - [Net Rate Act 2]
317 Net Rate Act 2
Network Rate Actual 2
Displays the active network data rate at which interface n communicates.
301
Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017
Values
Default: 0
Min/Max: 0/255
Default: 0 = 'Autodetect'
Options: 0 = 'Autodetect'
1 = '10 Mbps Full'
2 = '10 Mbps Half'
3 = '100 Mbps Full'
4 = '100 Mbps Half'
Default: 0 = 'No Link'
Options: 0 = 'No Link'
1 = '10 Mbps Full'
2 = '10 Mbps Half'
3 = '100 Mbps Full'
4 = '100 Mbps Half'
5 = 'Dup IP Addr'
Default: 0 = 'Autodetect'
Options: 0 = 'Autodetect'
1 = '10 Mbps Full'
2 = '10 Mbps Half'
3 = '100 Mbps Full'
4 = '100 Mbps Half'
Default: 0 = 'No Link'
Options: 0 = 'No Link'
1 = '10 Mbps Full'
2 = '10 Mbps Half'
3 = '100 Mbps Full'
4 = '100 Mbps Half'
5 = 'Dup IP Addr'
Interface Parameters Appendix C
RW 32-bit 0
Integer
RW 32-bit 0
Integer
RO 32-bit 0
Integer
RW 32-bit 0
Integer
RO 32-bit 0
Integer
129