Communication Setting Using Parameter Method (Gx Developer) - Mitsubishi FX3U-USB-BD User Manual

FX Series PLC User's Manual - Data Communication Edition
Common Items
3.2

Communication Setting Using Parameter Method (GX Developer)

Communication settings may be changed by the parameter method with GX Developer and FXGP/WIN for
Windows. This section describes how to change parameters with GX Developer.
Ch0 cannot be set using GX Developer.
3.2.1 Operating procedure
With GX Developer open, follow the steps in this section for activating the serial communication setting
method.
1
Opening the parameter setting window
Double-click [Parameter] - [PLC parameter] from the project tree.
If the project tree is not displayed, select [View] - [Project data list] from the toolbar (to display a
check mark on the left side).
2
Setting the serial communication (parameters)
Click the [PLC system(2)] tab on the dialog box.
- When using programming communication, parallel link, N:N Network or remote maintenance, do not
check the "Operate communication setting" box.
- When using computer link, inverter communication or non-protocol communication (RS/RS2 instruction)
function, check the "Operate communication setting" box, and then set each item.
3
Writing parameters to the PLC
Select [Online] - [Write to PLC] from the toolbar, put a check mark next to "Parameter", and then
click [Execute].
A-56
3 Outline of Communication Setting in the FX Series
3.2 Communication Setting Using Parameter Method (GX Developer)