Basic Settings - Otto Bock B400 Instructions For Use Manual

Handover

6.2 Basic Settings

The following fitting tasks are described in more detail in the
included Instructions for Use (User) – reference number
647G945:
• Adjusting the seat
• Adjusting the side panels
• Adjusting the footrests
• Adjusting the belt lengths
• Adjusting the control panel
6.3 Changing control unit parameters
WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified per­
sonnel trained by the manufacturer. The manufacturer
of the product and the control unit manufacturer are
not liable in case of damage caused by programming
which was not performed properly and/or which was
not adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configura­
tion can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking
or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause
an accident.
14 | Ottobock
► After configuration/programming is complete, the user
must test the driving characteristics of the product
under the supervision of the qualified personnel.
6.3.1 Wheelchair control options
If necessary, the pre-programmed wheelchair control sys­
tem can be adjusted to the specific user requirements.
Further information on programming can be found in the
service manual (647G946=DE/647G946=EN)
Information on operation and troubleshooting of the wheel­
chair control unit can be found in the instructions for use
(user).
6.3.2 Attendant control
The power wheelchair can be ordered and equipped with an
attendant control. It may be necessary to fit the already
installed attendant control to the actual body size of the
attendant.
The instructions for use (user) contain information on oper­
ating the attendant control.
7 Handover
7.1 Final inspection
A final inspection should be performed before delivery of the
power wheelchair:
• Are all options installed according to the order form?
B400