Matco Tools FixAdvisor MD70 Operating Instruction page 68

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
5. Use the UP
available PIDs. When the PID you wish to record is highlighted,
press the ENTER
the checkbox to the right of the PID to confirm your selection).
Repeat the procedure until only the PIDs you want to record have all
been selected.
To deselect a currently selected PID, highlight the PID, then
press the ENTER
from the checkbox.
6. When you are finished making your selection(s), press the LD
button to save your selection. Proceed to step 7.
7. If DTCs are presently stored in the
vehicle's computer, an advisory message
displays. Use the UP
buttons, as necessary, to highlight Erase
DTCs, then press the ENTER
See ERASING DIAGNOSTIC TROUBLE
CODES (DTCs) on page 54.
8. When the "Ready to Record" screen
displays, put the engine in the operating
condition that causes the DTC to set.
If necessary, drive the vehicle until you
reach the vehicle speed at which the
problem occurs.
9. When the Scan Tool detects a fault that
causes a DTC to set, it automatically
records and saves approximately 100
frames of Live Data information in its
memory (according to your trigger selection)
for each PID supported by the vehicle.
All three LEDs will blink for three
seconds to indicate that Live Data is
being recorded, and a "One moment
please..." message shows on the
display, along with the number of the
frame being recorded.
When
confirmation screen displays, asking if
you would like to view the recorded
data. Use the UP
buttons, as necessary, to select Yes or
No, as desired, then press the ENTER
button.
66
and DOWN
button to select it. (a "checkmark" will show in
button. The checkmark will be removed
and DOWN
recording is complete,
and DOWN
buttons to scroll through the
button.
a
MD70