Viewing Abs Dtcs - Matco Tools FixAdvisor MD70 Operating Instruction

The FixAdvisor will display a code only if
codes are present in the vehicle's
computer memory. If no codes are
present, a "No Enhanced DTC's are
presently
computer"
SYSTEM
System Menu.
3. If more than one code was retrieved press the DTC/FF button, as
necessary, to display additional codes one at a time.
Whenever the Scroll function is used to view additional codes,
the Scan Tool's communication link with the vehicle's computer
disconnects.
POWER/LINK
4. When the last retrieved DTC has been displayed and the DTC/FF
button is pressed, the Scan Tool returns to the Toyota/Lexus
Enhanced menu.
To view additional enhanced DTCs, repeat steps 1 through 4,
above.
To exit the enhanced mode, press the SYSTEM MENU
button. The Scan Tool returns to the System Menu.

VIEWING ABS DTCs

Refer to Vehicle Applications - ABS on page 85 for vehicles
covered.
1. When ABS is chosen from the System Menu, a "One moment
please" message displays while the FixAdvisor retrieves the
selected DTCs.
A "One moment please" message
displays while the FixAdvisor retrieves
the selected DTCs.
If the FixAdvisor fails to link to the
vehicle's computer, a "Linking Failed"
message shows on the FixAdvisor's
display.
- Verify the ignition is ON, then press
the POWER/LINK
continue.
2. To read the display:
MD70
Using the FixAdvisor Pro
In the case of long code definitions, a small arrow is
shown in the upper/lower right-hand corner of the code
display area to indicate the presence of additional
information. Use the
to view the additional information.
stored in the
is displayed.
button to return to the
To re-establish
button again.
VIEWING ABS DTCS
and buttons, as necessary,
vehicle's
Press the
communication,
button to
™
press the
51