Matco Tools FixAdvisor MD70 Operating Instruction page 55

1. When SRS is chosen from the System Menu, a "One moment
please" message displays while the FixAdvisor retrieves the
selected DTCs.
A "One moment please" message
displays while the FixAdvisor retrieves
the selected DTCs.
If the FixAdvisor fails to link to the
vehicle's computer, a "Linking Failed"
message shows on the FixAdvisor's
display.
- Verify the ignition is ON, then press
the ENTER
2. To read the display:
Refer to DISPLAY FUNCTIONS on page 11 for a description
of LCD display elements.
A visible
FixAdvisor is being powered through
the vehicle's DLC connector.
A visible
FixAdvisor is linked to (communicating
with) the vehicle's computer.
The upper right hand corner of the
display shows the number of the code
currently being displayed, the total
number of codes retrieved.
The Diagnostic Trouble Code (DTC) and related code definition
are shown in the lower section of the LCD display.
I/M MONITOR STATUS icons are not displayed when viewing
SRS DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information. Use the UP
and DOWN
information.
The FixAdvisor will display a code only if
codes are present in the vehicle's
computer memory. If no codes are
present, a "No SRS DTC's are presently
stored in the vehicle's computer" is
displayed. Press the SYSTEM MENU
button to return to the System Menu.
3. If more than one code was retrieved press the DTC/FF button, as
necessary, to display additional codes one at a time.
MD70
Using the FixAdvisor
button to continue.
icon indicates that the
icon indicates that the
buttons, as necessary, to view the additional
VIEWING SRS DTCS
53
™