S Ettings - CalAmp Dataradio Sentry 4G 900 User Manual

The following should be entered into a browser on a remote PC to remote login to the Sentry 4G
router. The Sentry 4G unit must have remote administration enabled for this functionality to work.
Note: "HTTP" must be
specified or browser will
assume other uses
"WWAN IP Address"
On Unit Status page
General Settings-Power Management
5.7.4
The SENTRY 4G unit is designed to stay ON even if the ignition is turned OFF. You can configure your
Sentry 4G unit to automatically shut down 1, 5, 30, or 60 minutes after ignition is turned off or when
the supply voltage drops to a certain level.
Shutdown Method: Disabled by default (unit always ON after ignition is turned OFF). Select
"Power Off" to enable power management.
After ignition line off: Select between the following time intervals: 1 minute, 5 minutes, 30
minutes, or 60 minutes.
When Voltage Drops to: Enter desired voltage. Enter "0" to disable. (Note: A value of 11V would
be usually entered here as a precaution in order to ensure the car battery does not drain.)
5.8 GPS Status and Settings
The Sentry 4G unit incorporates a highly sensitive 16-channel GPS receiver and an intelligent
algorithm that offers outstanding receive sensitivity. Summarized below are the specifications of the
integrated GPS module:
001-9193-001 Version 1
http://70.209.115.93:8080
Figure 25 - Example of Remote Login
Figure 26 - Power Management
Page 38 of 48
CONFIGURATION
"Configuration Port" on
"Remote Administation"
page.
Sentry 4G 900 TM User Manual