CalAmp Dataradio Sentry 4G 900 User Manual page 28

WiFi (WLAN)Wireless Settings (Client)
5.5.2
The user can configure up to 20 access points.
Note: All access points must run a DHCP server.
In wireless client mode, the Sentry 4G unit will try to connect to the Access Point with the strongest
signal on the list. When the Sentry 4G unit connects to an access point, it starts a DHCP client
service. The DHCP server running on the access point must provide an IP address, netmask, and
gateway to the Sentry 4G unit. When the WiFi client is connected to a WiFi access point, the default
route is set to point to the gateway address obtained by the DHCP client.
Wireless Settings
Access Point Number: Access point number
SSID: Service Set Identifier. This is the name of the wireless local area network.
Channel: Channel number to use (Auto or 1-11)
Authentication: Authentication method to be used (Example: Open, Shared, WPANONE,
WPA-PSK, WPA2-PSK)
Encryption: None, WEP, TKIP, or AES
WEP Key Length: the bit key length
WEP Key Type: type of WEP security
WEP Key Index: 1-4
Key: The encryption key
001-9193-001 Version 1
Figure 15 - WiFi (WLAN)
Page 28 of 48
Wireless Settings (Client)

CONFIGURATION
Sentry 4G 900 TM User Manual