Panel - CalAmp Dataradio Sentry 4G 900 User Manual

2.3 External Interfaces
Front Panel Connections
2.3.1
Sentry 4G router front panel connections include:
TRX: Two TNC female, Transmit/Receive antenna connections. See section 2.6 "Antenna
options" for more information.
WiFi: RP-SMA jack, WiFi antenna. See section 2.6 "Antenna options" for more information.
ETH0 and ETH1: Inputs for standard or crossover Ethernet cable
GPS: SMA female, GPS antenna connector. This input requires a 3.3V, GPS antenna with an
SMA connection. For best coverage, use an active GPS antenna with a gain between 10 and
30 dB.
USB: USB A Female connector. Reserved for future use.
Console: 3-wire serial in a USB Mini B female form factor (requires a custom USB Mini B to
EIA-232-F DB9 cable) for debugging and maintenance only.
PWR: 10-30 VDC; the mating connector is a Weidmuller 1615800000 connector.
LEDs
2.3.2
There are seven LEDs on the front panel of the Sentry 4G unit. Each can display three colors:
Red, Green, and Amber. The definition for each LED is as follows:
Table 1 - LED Definitions
INDICATOR OFF
PWR No Power
(Power)
STAT (Status) No Power
GPS GPS
Disabled
4G (WWAN) I/F
Disabled
WiFi (client) N/A
WiFi (Access IF/Disabled
001-9193-001 Version 1
Figure 1 - Dataradio Sentry 4G Router Front Panel
SOLID FLASHING
GREEN GREEN
Power on Test Mode
App.Running
Status N/A
Normal
Position Fix 1PPS
Acquired Activity
Connected RX/TX
Activity
Connected RX/TX
Activity
Ready RX/TX
Page 7 of 48
SOLID FLASHING
AMBER AMBER
Hardware Software
Power up boot
Sequence sequence
Warning Factory
Defaults
No Acquiring
Satellites Satellites
in View
Failed to Establishing
establish Connection
connection
Failed to Establishing
establish Connection
connection
N/A N/A
Sentry 4G 900
PRODUCT OVERVIEW
SOLID FLASHING
RED RED
Power N/A
Supply
Fault
Fault N/A
Fault N/A
Fault N/A
Fault N/A
Fault N/A
TM User Manual