CalAmp Dataradio Sentry 4G 900 User Manual page 24

5.4 LAN Settings (ETH0 and ETH1)
Sentry4G router features two Ethernet ports. The ETH0 and ETH1 Settings pages contain the
basic configuration information required to customize your LAN with the Sentry 4G router as
the network connection point. User configuration will primarily occur on this page.
IP Settings
5.4.1
5.4.1.1 IP Configuration
Ethernet IP address: LAN IP of the SENTRY 4G unit. This address is entered into a browser
on a local PC when logging into the Sentry 4G home page. To decrease the chances of
unwanted access, this value should be changed from its default prior to use.
IMPORTANT NOTE:
Changing this value will cause you to lose connection to the Sentry 4G unit.
Enter the new address in the browser to reconnect. If you forget an address or
make a mistake entering the new value, it may be difficult to reconnect to the
device.
Ethernet Subnet Mask: The Subnet mask is used in conjunction with the Ethernet IP
address to partition the address into the network (subnet) portion and the host portion. This
value will be entered automatically by the software based on the class of IP address entered.
It is not be necessary to change the default value once the Ethernet IP is entered.
5.4.1.2 DNS Masquerade
See the definition for DNS in Network Basics in section 3.1 above.
001-9193-001 Version 1
Figure 12 - IP Settings
Page 24 of 48
CONFIGURATION
Sentry 4G 900 TM User Manual