CalAmp Dataradio Sentry 4G 900 User Manual page 20

Home Page Parameter Descriptions
5.2.1
System Information
Unit ID: Sentry4G unit identification number (configured under General Settings).
System Up Time: System Up Time displays a counter that starts when the unit is powered
on and resets when the unit is powered down or hardware reset.
Software Version: This reflects the version of application software loaded on the unit.
WWAN
Interface Status: indicates if the device has an established connection to the WWAN. Status
is UP or DOWN
IP Address: WWAN IP address of the Sentry 4G unit.
Subnet Mask: This subnet mask of the WWAN interface
MAC Address: Media Access Control Address of the WWAAN interface.
ETH0 and ETH1
Interface Status: indicates if the device has an established connection to the LAN on ETH0
or ETH1 interface. Status is UP or DOWN
IP Address: IP address assigned to the ETH0/ETH1 interface
Subnet Mask: The Subnet mask assigned to the ETH0/ETH1 interface
MAC Address: Media Access Control Address of the ETH0/ETH1 interface
WLAN (Access Point or Client)
Interface Status: Indicates if the WiFi interface is "UP" or "DOWN"
IP Address: IP address assigned to the WiFi interface of this device. When the WiFi
interface is set to operate in WiFi Client mode, the WiFi Access Point must have a DHCP
server running to assign an IP address to its WiFi clients.
Subnet Mask: Subnet Mask assigned to the WiFi interface of this device.
MAC Address: Media Access Control Address of the WiFi interface.
5.3 WWAN Parameters
This page contains WWAN configuration information and settings.
Main
5.3.1
This screen contains main WWAN configuration. Select "Enabled" to enable WWAN interface and
"Disabled" to disable WWWAN interface. See Figure 9.
001-9193-001 Version 1 Page 20 of 48
CONFIGURATION
Sentry 4G 900 TM User Manual