Display Iiiumination Color Setting - Alinco DR-138 Instruction Manual

8
General Setting

Display iiiumination color setting

This is to select the display illumination color.
1.
Press and hold /
CALL
2.
Press / key to choose No.22
CALL MONI
menu, LCD displays "COL--ORG".
3.
Turn selector knob to select the desired
color. Available colors are: ORG-
Orange, PUR-Purple, and BLU-Blue.
4.
Press key to confirm and exit.
TS/DCS
Scan resume Time Setup
There are 3 kinds of scan resume conditions.
1.
Press and hold
23
enter setting menu.
2.
Press / key to choose No.23
MONI
CALL
menu, LCD displays "SCAN--TO".
3. Turn selector knob to select the desired
Scan Resume Time.
TO: Timed Scan, it resumes scanning
after receiving 5s or when the signal is
gone, which ever faster.
CO: Busy Scan, it resumes scanning when the receiving signal is
gone.
SE: Stops scanning when a signal is received.
4.
Press key to confirm the selection and exit.
TS/DCS
key for over 2s to enter setting menu.
MONI
key for over 2s to
LCD dimmer
1.
Press and hold key for over 2s to
enter setting menu.
2.
Press / key to choose No.24
MONI
CALL
menu, LCD displays "LAMP--25"
3. Turn selector knob to select the desired LCD brightness; 1 to turn
off, 32 to the brightest.
4.
Press key to confirm and exit.
TS/DCS
tone-burst tones
1.
Press and hold key for over 2s to enter setting menu.
2.
Press / key to choose No.25
CALL MONI
menu, LCD displays"TB--1750".
3.
Turn selector knob to select the desired
pilot frequency.
1750HZ: Tone-burst tone.
2100HZ: Tone-burst tone.
1000HZ: Tone-burst tone.
1450HZ: Tone-burst tone.
4.
Press key to confirm the selection and exit.
TS/DCS
Display Mode Setup
There are 3 different dispaly modes: Frequency+Memory mode,
Channel mode&Channel+Name Tag mode.
1.
Press and hold key for over 2s to enter setting menu.