Anti-Theft Alarm - Alinco DR-138 Instruction Manual

This function is mainly use for simple anti-theft alarm device in vehicles.
When the transceiver be removed in an improper manner,the transceiver
will emit and transmit alarming and background voice to system and
other transceiver of the same frequency.
Alarm cable
[QL-01(A)]
Steering-wheel etc.
[QL-01(B)]
Connect DC power cable with car battery.
1. Connect the optional alarm cable QL-01(A) to the data jack on
the front panel as shown. Secure the other end of the cable to an
object that stays fixed in vehicle. (Note: if alarm cable QL-01 (A) is
not enough long, you can choose optional alarm cable QL-01 (B) to
extend).
2. When transceiver power off by press
key ,the long-distance anti-theft
alarm enable.
3. Note:The long-distance anti-theft alarm only available when
transceiver power off .
DC power cable
Battery
Alarm cable [QL-01(B)]

Anti-theft Alarm

4. When the alarm cable QL-01(A) or QL-01(B) is removed from the
DATA jack or cut by improper sequence, the alarm function enable
and will alarm as programmed. In alarming,the transceiver will stop
alarm once receiving a matching signal. And alarm again when a
matching signal disappeared.
5.
Restart radio to cancel anti-theft alarming.Reconnect with alarm
cable and turn off radio,the system will return to alarm mode.
10
30