Scan Skip - Alinco DR-138 Instruction Manual

9
When first bit of Exa byte in frequency displays "F",it
indicates 5Tone function enable.
This function can be temporarily used in channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.

Scan Skip

In Channel mode,press
between frequency's ten digit and unit digit,it means current channel is
scan skip. Repeat above operation to set scan or scan skip in current
channel.
1.
decimal point displayed between frequency's ten digit and unit
digit,it means current channel is scanned skip.
2. decimal point is not displayed between frequency's ten digit and
27
unit digit,it means current channel is scanned.
Frequency/Channel scan
In corresponding mode,press
scanning.
In scanning mode,press
Busy Channel Lockout
BCLO is to disable transmitting while RX signal is received. Once the
channel is busy and you press PTT, the radio will beep as warning and
get back to receiving.
1.
In standby,press
Lockout.
2. Press [ /
then press ,decimal point displayed
then press key to enter into
/ to change scan direction.
,then press to enter into Busy Channel
] to select the desired value.
BU: Enable BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a matching carrier;press [PTT] to emit error
voice prompt.
RL: Enable BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS.press
[PTT] to emit error voice prompt It can transmit in any receiving
status.
OFF: Busy channel lockout is disabled.
3. Press number keys to confirm and exit.
This function can be temporarily used in Channel mode . Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Reverse TX/RX
TX frequency turns to RX frequency & RX
frequency changes to TX frequency. The
signaling will also be reversed if CTCSS/DCS
signaling exited in this channel.
1.
In standby,press ,then press
2. Press [ / ] to select the desired value.
ON:Enable Frequency Reverse
OFF:Disable Frequency Reverse
3.
Press number keys to confirm and exit.
This function can be temporarily used in Channel mode . Once
the radio is turned off or switched to another channel, the
temporary setting will be erased and back to initial settings.
,LCD displays "REV—OF".