Initial Installation - Alinco DR-138 Instruction Manual

Mobile installation
The transceiver may be installed in any position in your car, where the
controls and microphone are easily accessible and it does not interfere
with the safe operation of the vehicle or the performance of the set.
If your vehicle is equipped with air bags, be certain your radio will not
interfere with their deployment. If you are uncertain about where to
mount the unit, contact your vehicle's manufacturer.
1.
Install the mounting bracket in the vehicle using the supplied self-
tapping screws (4pcs) and flat washers (4pcs).
2.
Position the transceiver, then insert and tighten the supplied
hexagon SEMS screws.
Double check that all screws are tightened to prevent vehicle
vibration from loosening the bracket or transceiver.
Car body
Washer (M5)
Tapping screw
(M5x20mm)
Mounting bracket
Caution:
Use only the provided screws
otherwise you risk damaging the
circuit board, components or fall-off
of the unit.

Initial Installation

Determine the appropriate angle of the transceiver, using the 3 screw
hole positions on the side of the mounting bracket.
3
2